What years will a 4l60e transmission fit?

What years are interchangeable for 4L60E?

The key distinction of the Later 4L60-E (1996-2010) from the Early 4L60-E (1992-1997), 4L60 (1990-1992), or 700R4 (1982-1989) is the six-bolt “hex” rear output or tailhousing / adapter pattern.

What vehicles does a 4L60E transmission fit?

What Vehicles Have A 4l60e Transmission?

  • Buick Rainier 2004-2007.
  • Buick Roadmaster 1994–1996.
  • Cadillac Escalade 1999-2000, 2002-2005 (models with LM7/5.3L V8 Also with 6.0 LQ9)
  • Cadillac Fleetwood 1994–1996.
  • Chevrolet Astro 1993-2005.
  • Chevrolet Avalanche 2002-2008.
  • Chevrolet S-10 Blazer 1994-2005.
  • Chevrolet Camaro 1994–2002.

Is there 2 different 4L60E transmissions?

The two transmissions cannot be differentiated from the outside. The 4L65E shares the same exterior parts but have stronger internals such as 5 pinion planets compared to 4 in the 4L60E. 4L60E uses a 6.5″ depth bell with 6 bolts for non gen 3 LS applications and a 7″ depth bell with 7 bolts for LS applications.

Will a 98 4L60E fit a 2001?

5 Answers. Yes, it will bolt right up in there, but make sure the length of the transmission is the same, and the Tahoe would have to be a 4-wheel drive vehicle, and check out the electrical connections to make sure they are the same.

THIS IS IMPORTANT:  How do I protect my white leather car seats?

What engines bolt up to 4L60E?

In most cases, you can use the 4L60E trans with its 298mm style converter behind a normal, six-bolt LS crank flange engine (4.8L, 5.2L, 5.7L, 6.0L, and 6.2L). Truck engines such as the 4.8L, 5.3L, and 6.0L used a dished flexplate to place the starter ring gear in the correct position.

What is the difference between a 4L60 and a 4L60E transmission?

The rear output housing is configured with a six-bolt pattern in late model 4L60E transmissions. The 4L60 transmission is configured with a four-bolt pattern. The bolt pattern is not a guaranteed distinction, however, as early 4L60E transmissions, manufactured from 1992 through 1997, also have a four-bolt pattern.

How do I know if I have a 4L60E transmission?

Four bolts connect the tail shaft (or transfer case) to the transmission. The vehicle speed sensor changed locations during the production run. There is an information sticker on top of the bell housing at the very top of the transmission.

What does 4L60E stand for?

In 1990, the 700-R4 was redesignated the 4L60, with “4” meaning four-speed, “L” for longitudinal installation (north/south), and “60” meaning light-to-medium-duty use and 6,000-pounds gross vehicle weight.

Can a 4L80E replace a 4L60E?

The 4L80E has a maximum engine torque rating of 440 lb-ft and a maximum gearbox torque rating of 885 lb-ft. What this boils down to is that the 4L80E offers an 80 lb-ft and 275 lb-ft improvement over the 4L60E in both areas, respectively.

Are 4L60E and 4L70E interchangeable?

They all use the same oil pans and the designations are interchangeable depending on the year and build of the transmission. Between the 4L60E and the 4L70E, the biggest difference is time. The 4L70E is a straight upgrade to the 4L60E, appearing on the market several years after the 4L60E has had time to shine.

THIS IS IMPORTANT:  How do you fix low engine power?

What’s the difference between 4L60E and 4L80E?

The 4L80E is larger and heavier than the 4L60E. Its more hefty build can be tied to its 236 lbs and a length of 26.4″. Alternatively, the 4L60E weighs 150 lbs (without fluid) and it has a length of 23.5″. A comparison between the size and weight shows that the 4L80E is significantly larger and heavier.

Will a 2wd 4L60E work in a 4wd?

These are externally interchangeable. The 4wd version reduces NVH induced by the transfer case hanging way behind the trans mount. When I did my 4L80 swap, I started with a 2wd trans that I converted and rebuilt.

Are all 4L60E valve bodies the same?

There were updates made to it over the years, so not every 4L60 valve body is the same. Some of the differences include the number of solenoids, as well as the type of 4L60E TCC solenoid and 4L60E 3-2 control solenoid.

Are all 4L80E transmissions the same?

4L80E Differences:

’91 -’96: They are all pretty much the same. They were also known to have a crappy connector that passes through the case. Most have had them updated by now, but there are still some that haven’t and might need replacing.